Looking for a coil for DE LW3 that runs the pop bumper. new or used is fine, just needs to be working and not melted.
Let me know if you can help me out.
Thx
Let me know if you can help me out.
Thx
WTB Data East 23-800 coil Part #090-5001-01
- Thread starter spikedbat
- Start date
sylvain
Active Member
Just curious, did you have a chance to troubleshoot and fix the root-cause of this melted coil ?
A melted / burned coil in those games is often an indication of an associated shorted drive transistor,
and possibly an overfused F5 fuse on the power supply.
So a new replacement coil will burn again quickly unless the actual root-cause issue is fixed.
(this reply post might hopefully be useful for pinball owners with limited electronics/pinball repair experience,
but would not be very useful to experienced techs who might think this is obvious).
Good luck with your LW3 !
A melted / burned coil in those games is often an indication of an associated shorted drive transistor,
and possibly an overfused F5 fuse on the power supply.
So a new replacement coil will burn again quickly unless the actual root-cause issue is fixed.
(this reply post might hopefully be useful for pinball owners with limited electronics/pinball repair experience,
but would not be very useful to experienced techs who might think this is obvious).
Good luck with your LW3 !
Yes I’ve replaced all the blown devices up stream. There were a couple of issues.
That would be great I’m just trying to figure out when I’d would have time to get out there.