1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Centipede sound issue

Discussion in 'Arcade Tech Support' started by slither, Dec 28, 2019.

  1. slither

    slither Member

    Joined:
    Mar 23, 2013
    Messages:
    222
    Likes Received:
    6
    Location:
    Portland, Ont.
    So my centipede cab sat for a few months . When I plugged it in, game played but no sound, rebooted a few times and got very low, minimal sound, then on next start up jumbled screen. I sent both the mpu and ARII boards out and had them looked at. the game now plays again (bad rom). On start up however , there is no sound, it comes on at very very low level after about 30-45 seconds. you can barely hear it. the volume pot seems to be working as you can increase /decrease the sound , funny thing is if I activate the slam switch on the door, there is a very loud scratchy/squealing noise, but the game sounds are now at proper volume, until I release the slam switch. Any ideas ?. Thanks..
     
    #1

Share This Page