Been in my collection for about 5 years. I put it on location and it survived well for several months until the time expander started getting stuck going up and down in the same spot. I figured it was a job that needed to be done at home so I pulled the machine off of location.
I have not gotten around to fixing it yet. I had to steal the driver board out of it to stick in a whodunit that I have rented out to a friend. So my doctor who will come with the Whodunnit board. The issue with that board is that the F116 fuse keeps blowing. I might actually have that remedied though this week.
I led'd the Playfield. Other than the stated issues that machine is very solid and has been since I've had it. I recently rebuilt the upper flipper. It comes with the 3-piece cliffy set, two of which are installed.
I sliced off a bit of mylar that was bubbled up. There is still 97% of the mylar on the playfield but one could remove it all if they would like as the Playfield is in great condition with diamond coat finish.
I have not gotten around to fixing it yet. I had to steal the driver board out of it to stick in a whodunit that I have rented out to a friend. So my doctor who will come with the Whodunnit board. The issue with that board is that the F116 fuse keeps blowing. I might actually have that remedied though this week.
I led'd the Playfield. Other than the stated issues that machine is very solid and has been since I've had it. I recently rebuilt the upper flipper. It comes with the 3-piece cliffy set, two of which are installed.
I sliced off a bit of mylar that was bubbled up. There is still 97% of the mylar on the playfield but one could remove it all if they would like as the Playfield is in great condition with diamond coat finish.
Last edited:
